Based on inverter data, allow specifying the fault current contribution over different cycles after initiation of faults.

I would like different analysis reports to be exported to a single Excel file but in different tabs. For example, short circuit can have different reports for Momentary, Interrupting, 30-cycle, HV, LV, Equipment Duty.

Model the Rating Thermal Method of SEL-749M. When selected, the relay configures a thermal curve based on the motor Full Load Amps, Service Factor, Run State Time Constant, Locked Rotor Amps, Hot Locked Rotor Time, and Acceleration Factor (Locked ...

Is there a way to allow for a cable length variance of a certain percentage (Say15% variance) for all cables in the model for short circuit analysis?

I would like to create labels such that the same label has arc flash results for both line side and load of the main breaker.

In the Database Report we show the alternate rows highlighted. This makes it easy to ready horizontally across the page. The Browser (grid) does not have that formatting. It will be easier in the browser too if we added highlighting in alternate r...

We are facing challenges with DC arc flash assessments. The main issue is that the NFPA 70E Annex D.5 Max Power equation for DC incident energy calculations, which we have found to yield overly conservative results, particularly for battery banks....

I would like to be able to view the TCC cursor crosshair to extend to the current and time axes for better readability.

I would like to remove EasyPower appended ID Name suffix text by replacing a given substring with a blank. The dialog does not accept a blank in the field "With these characters".

When printing one-lines, there is not currently a way to indicate automatically what the current view, or data-block, or calculation is set to. For example, if I have a One-line showing Arc Flash calculations for a specific scenario, or base case,...